Products > Gas flare unit

Online Shop -Show Cart | Total:

The flare burner unit can be used to burn off any gas from LPG pipes or vessels and natural gas where direct vented gas could cause a problem, due to smell or environmental concerns.

The unit contains a continuously rated high voltage transformer (fed from 110V source) that provides a continuous spark for ignition of the flame. This is particularly important when the gas is being purged with air or nitrogen and the gas concentration falls below 50%. It is normal to uses a 110V safety supply/transformer.

The burner head is mounted approximately 2.5m above the ground level and in most conditions will not cause a hazard to persons nearby. However, its use is not recommended in gusting winds.

The flare unit is mounted in a vinyl coated wooden and aluminium framed purge box that provides a stable base on firm ground conditions. The Flare Assembly consists of three vertical 15mm steel pipes connected with brass or stainless steel unions and a valved section containing an in-line flame arrestor.

Supplied with either 5m long natural gas hose or 10m long LPG hose

Pressure breakdown assemblies are also available for use with this unit

.The flare unit can be supplied as an intergrated assembly with our direct purging SPU and MPU units - contact GEA for details

Stand alone flare Assembly SFU £870 + VAT

(delivery included for Mainland UK)

Larger flare units with twin flare burners are available on request

The advantages of flaring

Terms and Conditions

ORDER ONLINE